CLI Reference CFM Configuration Commands
Ruijie# show cfm mep-list service-instance 1
Set the MEP (maintenance
association end point).
cfm mip-rule
service-instance
Set the rule of generating the
maintenance domain intermediate
point.
show cfm mp
Use this command to show the MP(maintenance point) information.
show cfm mp [interface interface-id]
By default, information of maintenance points on all interfaces
(including the MEP(maintenance association end point) and
maintenance domain intermediate point) are shown.
Ruijie# show mp interface gigabitethernet 1/1
Set the MEP (maintenance
association end point).
cfm mip-rule
service-instance
Set the rule of generating the
maintenance domain intermediate
point.
To Next Page
Loading...
Need help?
General