CLI Reference Guide Basic Configuration Management
Regard data output as the input to determine whether timeouts.
The default timeout is 0 min.
If there is no input/output information for the session to the remote terminal established in current
LINE within specified time, this connection will be interrupted, and this LINE will be restored to
the free status.
The example below specifies the timeout of session is 5 minutes.
Ruijie(config-line)#exec-timeout 5 output
show boot
Use this command to show the boot related configuration of the device.
show boot { config | network |system [ switch all | switchid ] | ip }
Show the configuration of the startup-config filename.
Show the configuration of the network startup-config filename.
Show the configuration of the startup main program filename.
Show the configuration of local IP address used in the device starting.
Show the boot path information of all devices in the VSU system in VSU
mode.
To Next Page
Loading...
Need help?
General