CLI Reference IPv6 Configuration Commands
ipv6 nd ns-interval
Use this command to set the interval for the interface to retransmitting NS (Neighbor Solicitation). Use
the no form of this command to restore it to the default setting.
ipv6 nd ns-interval milliseconds
Interval for retransmitting NS in the range of 1000 to 429467295
milliseconds
The default value in RA is 0 (unspecified); the interval for retransmitting NS is 1000ms(1s).
Interface configuration mode.
The configured value will be advertised through RA and will be used by the device itself. It is not
recommended to set a too short interval.
Ruijie(conifig-if)# ipv6 nd ns-interval 2000
Show the interface information.
Use this command to configure the address prefix included in the RA. Use the no form of this
command to delete the set prefix or restore it to the default setting.
ipv6 nd prefix { ipv6-prefix/prefix-length | default } [ [ valid-lifetime preferred-lifetime ] | [ at valid-date
preferred-date ] | [infinite | preferred-lifetime ] ] [no-advertise] | [[ off-link ] [ no-autoconfig ] ]
no ipv6 nd prefix { ipv6-prefix/prefix-length | default } [ [ off-link ] [ no-autoconfig ] |
[ no-advertise ] ]
IPv6 network ID following the format defined in RFC4291
Length of the IPv6 prefix. “/” shall be added in front of the prefix
Valid lifetime of the RA prefix received by the host
To Next Page
Loading...
Need help?
General