CLI Reference IPv6 Configuration Commands
Ruijie(config-if)# ipv6 nd managed-config-flag
Show the interface information.
ipv6 nd other-config-flag
Set the flag for obtaining all information except
IP address through stateful auto configuration.
ipv6 nd other-config-flag
Use this command to set “other stateful configuration” flag bit of the RA message. Use the no form of
this command to delete the flag bit.
ipv6 nd other-config-flag
no ipv6 nd other-config-flag
The flag bit is not set by default.
Interface configuration mode.
With this flag bit set, the flag bit of the RA message sent by the device is set. After receiving this flag
bit, the host uses the dhcpv6 to acquire the information excluding the IPv6 address for the purpose of
automatic configuration. When the managed address configuration is set, the default other
stateful configuration is also set
Ruijie(config-if)# ipv6 nd other-config-flag
Show the interface information.
To Next Page
Loading...
Need help?
General