CLI ReferenceInterface Configuration Commands Interface Configuration Commands
The command does not support the no parameter, so this interface type cannot be
deleted. Use show interfaces or show interfaces gigabitEthernet to display the
interface configuration.
Ruijie(config)# interface gigabitEthernet 1/2
Ruijie(config-if)#
Show the interface information.
interface tenGiagbitEthernet
Use this command to select a 10G Ethernet interface, and enter the interface
configuration mode.
interface tenGigabitEthernet mod-num/port-num
The range varies with the device and the extended module.
Global configuration mode.
The command does not support the no parameter, so this interface type cannot be
deleted. Use show interfaces or show interfaces tenGigabitEthernet to display
the interface configuration.
Ruijie(config)# interface tenGigabitEthernet 1/2
Ruijie(config-if)#
Show the interface information.
No product supports this command till now.
Use the interface vlan command in the global configuration mode to access or