Ruijie RG-S2600G-I Series User Manual

CLI Reference Guide Cluster Management Configuration Commands
temporarily.
Default
No cluster-shared TFTP server is configured by default.
Command
mode
Global configuration mode.
Usage
guidelines
This command can be executed on the commander device only. Input
the command show cluster in the Privileged EXEC mode to show
the related configurations.
Examples
The following example sets the IP address of the cluster-shared
TFTP server as 172.10.1.1
Ruijie(config)# cluster tftp-server 172.10.1.1
Related
commands
Command
Description
show cluster
Show the basic information of the
cluster to which the device
belongs.
show cluster
candidates
Show the candidate devices.
show cluster
member
Show the member devices.
cluster timer
Use this command to set the cluster timer, which is the interval of sending the topology discovery
information on the commander device. This value shall be less than the cluster holdtime, otherwise,
the cluster topology information generates and becomes invalid frequently, resulting in unstable
topology. Use the no form of this command to restore the timer to the default value.
cluster timer interval-in-secs
no cluster timer
Parameter
description
Parameter
Description
interval-in-secs
Set the timer ranging from 30 to 300
seconds. The default value is 60
seconds.
Default
60 seconds.

Ruijie RG-S2600G-I Series Specifications

General

Brand	Ruijie
Model	RG-S2600G-I Series
Category	Switch
Language	English