CLI Reference IPSource Guard Configuration Commands
show ip source binding
Use this command to view the binding information of IP source address and database.
show ip binding [ip-address] [mac-address] [dhcp-snooping] [static] [vlan vlan-id]
[interface interface-id]
Show user binding information of
corresponding ip.
Show user binding information of
corresponding mac.
Show binding information of dynamic user.
Show binding information of static user.
Show user binding information of
corresponding vlan.
Show user binding information of
corresponding interface.
Ruijie# show ip source binding static
MacAddress IpAddress Lease(sec) Type VLAN Interface
------------- --------- ---------- ---- ---- ------------
0000.0000.0001 1.0.0.1 infinite static 1 FastEthernet 0/1
Total number of bindings: 1
Set the binding static user.
This command is supported on all switches.
To Next Page
Loading...
Need help?
General