CLI Reference Guide NTP Configuration Commands
The NTP message received on any interface can be provided to the
client to carry out the clock adjustment. The function can be set to
shield the NTP message received from the corresponding interface.
Note: The interface that is configured with this command can receive
and send IP packets. No this command is configured on other
interfaces.
The configuration example below disables the function of receiving
the NTP message on the interface.
Ruijie(config)#no ntp disable
ntp master
Use this command to configure the local time as the NTP master (the local time reference source is reliable),
providing the synchronizing time for other devices. Use the no form of this command to cancel the NTP master
settings.
ntp master [stratum]
no ntp master
Specify the stratum where the local time is, in the
range of 1-15. The defaut stratum is 8.
No NTP master is configured, by default.
Global configuration mode.
To Next Page
Loading...
Need help?
General