Ruijie RG-S2600G-I Series - Page 285

CLI ReferenceInterface Configuration CommandsProtocol Frames Transparent Transmission Configuration Commands
bridge-frame forwarding protocol cisco-pvst
Use the bridge-frame forwarding protocol cisco-pvst command to enable transparent transmission
of PVST frames. Use the no form of this command to disable transparent transmission of PVST
frames.
bridge-frame forwarding protocol cisco-pvst
no bridge-frame forwarding protocol cisco-pvst
Parameter
Description
Parameter
Description
-
-
Defaults
Transparent transmission of PVST frames is enabled on a device by default.
Command
Modes
Global configuration mode
Usage
Guidelines
-
Examples
Example 1: Enable transparent transmission of PVST frames on a device.
Ruijie(config)# bridge-frame forwarding protocol cisco-pvst
Example 2: Disable transparent transmission of PVST frames on a device.
Ruijie(config)# no bridge-frame forwarding protocol cisco-pvst
Related
Commands
Command
Description
-
-
Platform
Description
-