CLI Reference DHCPv6 Snooping Configuration Commands
writes the user information into the flash as 100s:
Ruijie(config)# ip dhcp snooping database write-delay 100
View the configuration information of the
DHCPv6 snooping.
This command is supported on all switches.
ipv6 dhcp snooping database write-to-flash
Use this command to write the dynamic user information of the DHCPv6 binding database into flash in
real time.
ipv6 dhcp snooping database write-to-flash
Global configuration mode.
Use this command to write the dynamic user information of the
DHCPv6 binding database into flash in real time.
The following is an example of writing the dynamic user
information of the DHCPv6 binding database into flash.
Ruijie(config)# ipv6 dhcp snooping database
write-to-flash
This command is supported on all switches.
ipv6 dhcp snooping filter-dhcp-pkt
Use this command to filter all received DHCPv6 request packets. The no form of this command will
disable this function.
ipv6 dhcp snooping filter-dhcp-pkt
no ipv6 dhcp snooping filter-dhcp-pkt
To Next Page
Loading...
Need help?
General