CLI Reference DHCPv6 Snooping Configuration Commands
Interface configuration mode.
Use this command to filter all received DHCPv6 request packets, that
is, to avoid all the DHCPv6 users on this interface to apply for the
addresses.
The following is an example of filtering all DHCPv6 request
packets on the interface fastethernet 0/1:
Ruijie(config)# interface fastethernet 0/1
Ruijie(config-if)# ipv6 dhcp snooping filter-dhcp-pkt
This command is supported on all switches.
ipv6 dhcp snooping ignore dest-not-found
Use this command to ignore the destination port not found. Use the no form of this command to restore
the DHCPv6 reply packet port check.
ipv6 dhcp snooping ignore dest-not-found
no ipv6 dhcp snooping ignore dest-not-found
Global configuration mode.
To Next Page
Loading...
