Ruijie RG-S2600G-I Series - Page 1150

CLI Reference Guide SNMP Configuration Commands
snmp trap link-status
Use this command to configure in a device whether to send LinkTrap of the interface based on the
interface configuration. When this function is enabled, SNMP will send LinkTrap if the link status of the
interface changes; otherwise, it will not send LinkTrap. When the no form of this command is used,
SNMP will not send LinkTrap.
snmp trap link-status
no snmp trap link-status
Parameter
Description
Parameter
Description
-
-
Defaults
By default, this function is enabled. If the link status of the interface changes, SNMP will send
LinkTrap.
Command
Mode
Interface configuration mode
Usage Guide
This command is used to configure whether to send LinkTrap of an interface, such as the Ethernet
interface, AP interface and SVI interface. When the function is enabled, if the link status of the
interface changes, SNMP will send LinkTrap; otherwise, it will not.
Configuration
Examples
Example 1: Configure not to send LinkTrap of the interface:
Ruijie(config)# interface gigabitEthernet 1/1
Ruijie(config-if)# no snmp trap link-status
Example 2: Configure to send LinkTrap of the interface:
Ruijie(config)# interface gigabitEthernet 1/1
Ruijie(config-if)# snmp trap link-status
Related
Commands
Command
Description
-
-
Platform
Description
-
snmp-server chassis-id
Use this command to specify the SNMP system sequential number in global configuration mode. The
no form of this command is used to restore it to the initial value.
snmp-server chassis-id text