At present, our system only support clients other than servers, and
the upper limit of supported synchronous servers are 20.
To carry out the encrypted communication with the server, set the
global encryption key and global trusted key firstly, and then specify
the corresponding key as the trusted key of the server to launch the
encrypted communication of the server. It requires the server
presents identical global encryption key and global trust key to
complete the encrypted communication with the server.
In the same condition (for instance, precision), the prefer clock is
used for synchronization.
It should be noted that the configured interface is that configured with
the IP address and can communicate with the corresponding NTP
server when you configure the source interface of the NTP message.
The configuration example below configures the equipment in the
network as NTP server.
For IPv4: Ruijie(config)# ntp server 192.168.210.222
For IPv6: Ruijie(config)# ntp server 10::2
To Next Page
Loading...
Need help?
General