CLI ReferenceInterface Configuration Commands Interface Configuration Commands
interface aggregateport
Use this command to access or create an aggregate port and enter the interface
configuration mode. Add no in the command to remove this port.
interface aggregateport port-number
Aggregate port number. Its range varies with the equipment
and extended modules.
Global configuration mode.
Based on certain rules, you can add other ports to an aggregate port. All the
members of an aggregate port are considered as a whole, and their attributes vary
with the ones of the aggregate port. You can use show interfaces or show
interfaces aggregateport commands to display the interface configuration.
Ruijie(config)#interface aggregateport 3
Ruijie(config-if)#
Show the interface information.
To Next Page
Loading...
