Ruijie RG-S2600G-I Series - Page 172

CLI ReferenceInterface Configuration Commands Interface Configuration Commands
line-detect
Use this command to detect the cable connection status.
line-detect
Parameter
Description
Parameter
Description
Defaults
Command Mode
Interface configuration mode.
Usage Guide
This command is used to show the line status and locate the cause of a line failure;
for example, the line is broken.
Configuration
Examples
Ruijie(config)#interface gigabitEthernet 0/1
Ruijie(config-if-GigabitEthernet 0/1)#line-detect
Interface : GigabitEthernet 0/1
start cable-diagnoses,please wait...
cable-daignoses end!this is result:
4 pairs
pair state length(meters)
---- ---------- --------------
A Ok 1
pair state length(meters)
---- ---------- --------------
B Ok 2
pair state length(meters)
---- ---------- --------------
C Short 1
pair state length(meters)
---- ---------- --------------
D Short 1
Field
Description