Ruijie RG-S2600G-I Series - Page 176

CLI ReferenceInterface Configuration Commands Interface Configuration Commands
snmp trap link-status
You can set up whether to send LinkTrap on an interface. If the function is enabled,
the SNMP will send the LinkTrap when the link status of the interface changes. The
no attribute of this command prevents the SNMP from sending the LinkTrap.
snmp trap link-status
no snmp trap link-status
Parameter
Description
Parameter
Description
Defaults
This function is enabled. If the link status of the port changes, the SNMP sends the
LinkTrap.
Command Mode
Interface configuration mode.
Usage Guide
For an interface such as Ethernet interface, AP interface, and SVI interface, this
command determines whether to send LinkTrap on the interface. If the function is
enabled, the SNMP sends the LinkTrap when the link status of the interface
changes.
Configuration
Examples
Do not send LinkTrap on the interface:
Ruijie(config)# interface gigabitEthernet 1/1
Ruijie(config-if)# no snmp trap link-status
Following configuration shows how to configure the interface to forwarding Link
trap:
Ruijie(config)# interface gigabitEthernet 1/1
Ruijie(config-if)# snmp trap link-status
Related
Commands
Command
Function
Ruijie(config-if)# snmp
trap link-status
Enable sending LinkTrap on the interface.
Ruijie(config-if)# no snmp
trap link-status
Disable sending LinkTrap on the interface.
Platform
Description
speed