Ruijie RG-S2600G-I Series - Page 225

CLI ReferenceInterface Configuration Commands VLAN Configuration Commands
no switchport access vlan
Parameter
Description
Parameter
Description
vlan-id
The VLAN ID at which the port to be added.
Defaults
By default, the switch port is an access port and the VLAN is VLAN 1.
Command
mode
Interface configuration mode.
Usage Guide
Enter one VLAN ID. The system will create a new one and add the interface to the VLAN if you enter
a new VLAN ID. If the VLAN ID already exists, the command adds the port to the VLAN.
If the port is a trunk port, the operation does not take effect.
Configuration
Examples
Ruijie(config)# interface gigabitethernet 1/1
Ruijie(config-if)# switchport access vlan 2
Related
Commands
Command
Description
switchport mode
Specify the interface as Layer 2 mode (switch
port mode).
switchport trunk
Use this command to specify a native VLAN
and the allowed-VLAN list for the trunkport.
Platform
Description
N/A
switchport mode
Use this command to specify a L2 interface (switch port) mode. You can specify this interface to be an
access port or a trunk port or an 802.1Q tunnel. Use the no form of the command to restore the
default setting.
switchport mode { access | trunk | hybrid | uplink | dot1q-tunnel }
no switchport mode
Parameter
Description
Parameter
Description
access
Configure the switch port as an access port.
trunk
Configure the switch port as a trunk port.
hybrid
Configure the switch port as a hybrid port.
uplink
Configure the switch port as an uplink port.
dot1q-tunnel
Configure the switch port as an 802.1Q tunnel port.
Defaults
By default, the switch port is an access port.