CLI ReferenceInterface Configuration Commands MSTP Configuration Commands
Global configuration mode
Ruijie(config)# spanning-tree portfast default
show spanning-tree interface
Show the global STP configuration.
spanning-tree reset
This command is used to restore the spanning-tree configuration to default. This command
does not have the no option.
spanning-tree reset
Global configuration mode
Ruijie(config)# spanning-tree reset
Show the global STP configuration.
show spanning-tree interface
Show the STP configuration of an interface.
spanning-tree tc-guard
This command is used to enable tc-guard on the interface to prevent the spread of TC
messages. You can use the no option of this command to disable tc-guard on the interface.
To Next Page
Loading...
Need help?
General