CLI ReferenceInterface Configuration Commands MSTP Configuration Commands
spanning-tree tc-protection tc-guard
This command is used to enable tc-guard globally to prevent the spread of TC messages. You
can use the no option of this command to disable tc-guard globally.
spanning-tree tc- protection tc-guard
no spanning-tree tc- protection tc-guard
Global configuration mode
Ruijie(config)# spanning-tree tc-protection tc-guard
spanning-tree tx-hold-count
This command is used to configure the TxHoldCount of the STP in the global configuration
mode and the maximum number of the BPDU messages sent in one second. You can use the
no option of the command to restore the default setting.
spanning-tree tx-hold-count tx-hold-count
no spanning-tree tx-hold-count
Set TxholdCount in the range from 1 to 10.
Global configuration mode