Ruijie RG-S2600G-I Series - Page 335

CLI ReferenceInterface Configuration Commands QinQ Configuration Commands
traffic-redirect access-group acl inner-vlan vid out
no traffic-redirect access-group acl inner-vlan
Parameter
description
Parameter
Description
acl
Flow matching.
vid
Modified inner vid
no
Remove the settings.
Default
configuration
None
Command
mode
Interface configuration mode.
Examples
Here is an example of configuring the outer vid of outgoing messages
whose source address is 1.1.1.2 as 6:
Ruijie#configure
Ruijie(config)#ip access-list standard to_6
Ruijie(config-std-nacl)#permit host 1.1.1.2
Ruijie(config-std-nacl)#exit
Ruijie(config)# interface gigabitEthernet 0/1
Ruijie(config-if)# switchport mode trunk
Ruijie(config-if)# traffic-redirect access-group to_6 inner-vlan
6 out
Ruijie(config-if)# end
Related
commands
Command
Description
show traffic-redirect
Platform
description
The software version must be RGOS10.3 and later.
traffic-redirect access-group acl nested-vlan
Use this command to configure vid add policy list based on flow on dot1q-tunne port.
traffic-redirect access-group acl nested-vlan vid in
no traffic-redirect access-group acl nested –vlan
Parameter
description
Parameter
Description
acl
Flow matching.
vid
vid list to be added.
no
Remove the settings.