Ruijie RG-S2600G-I Series - Page 344

CLI ReferenceInterface Configuration Commands QinQ Configuration Commands
Examples
ruijie# show interface vlan-mapping
Ports Type Status Destination-VID Source-VID-list
------------ ------ ----- ---------------- ---------------
Gi0/1 in active 5 3
Gi0/1 out active 3 5
Platform
description
The software version must be RGOS10.4 and later.
show registration-table
Use this command to show vid add policy list of protocol-based dot1q-tunnel port.
show registration-table [interface intf-id]
Parameter
description
Parameter
Description
intf-id
Specific Interface
Default
configuration
Null policy list.
Command
mode
Privileged EXEC mode.
Examples
Ruijie# show registration-table
Ports Type Outer-VID Inner-VID-list
--------- ------ ------- ------------------
Gi0/7 Add-outer 5 7-10,15,20-30
Platform
description
The software version must be RGOS10.3 and later.
show traffic-redirect
Use this command to show flow-based vid change or add policy list.
show traffic-redirect [interface intf-id]
Parameter
description
Parameter
Description
intf-id
Specific Interface
Default
configuration
Null policy list.