Ruijie RG-S2600G-I Series - Page 361

CLI Reference IP Address Configuration Commands
interface fastEthernet 0/1
ip directed-broadcast
Related
Commands
Command
Description
N/A
N/A
Platform
Description
This command is not supported on the Layer 2 switch.
ip mask-reply
Use this command to configure the RGOS software to respond the ICMP mask
request and send an ICMP response message in the interface configuration mode.
The no form of this command is used to prohibit from sending the ICMP mask
response message.
ip mask-reply
no ip mask-reply
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
By default, no ICMP mask response message is sent.
Command
mode
Interface configuration mode.
Usage Guide
Sometimes, a network device needs the subnet mask of a subnet on the Internet.
To obtain such information, the network device can send an ICMP mask request
message, and the network device that receives this message will send a mask
response message.
Configuration
Examples
The following is an example of setting the FastEthernet 0/1 interface of a device to
respond the ICMP mask request message.
interface fastEthernet 0/1
ip mask-reply
Related
Commands
Command
Description
Platform
Description
This command is not supported on the Layer 2 switch.