CLI Reference IP Address Configuration Commands
trusted-arp user-vlan
Use this command to execute the VLAN transformation while setting the trusted
ARP entries. The no form of this command deletes an ARP entry.
trusted-arp user-vlan vid1 translated-vlan vid2
no trusted-arp user-vlan vid1
VID after the transformation.
No VLAN transformation is executed.
Global configuration mode.
In order to validate this command, enable the trusted ARP function first. This
command is needed only when the VLAN sent by the server is different from the
VLAN which takes effect in the trusted ARP entry.
The following configuration is to set the VLAN sent by the server to 3, but the VLAN
which takes effect in the trusted ARP entry to 5.
trusted-arp user-vlan 3 translated-vlan 5
Enable the trusted ARP function.
This command is not supported by routers.
To Next Page
Loading...
Need help?
General