CLI Reference IPv6 Configuration Commands
Show the interface information.
Use this command to disable the interface from sending the RA message. Use the no form of this
command to enable the function.
The RA message is not sent on the IPv6 interface by default.
Interface configuration mode.
This command suppresses the sending of the RA message on an interface.
Ruijie(config-if)# ipv6 nd suppress-ra
Show the interface information.
Use this command to set the local address of the link as the source IP address to send neighbor
requests. When no ipv6 ns-linklocal-src is executed, the global IP address will be taken as the
source address to send neighbor requests.
To Next Page
Loading...
