Ruijie RG-S2600G-I Series User Manual

CLI Reference IPv6 Configuration Commands
Examples
Ruijie(config)# interface tunnel 1
Ruijie(config-if)# tunnel mode gre ip
Ruijie(config-if)# tunnel source vlan 1
Ruijie(config-if)# tunnel destination 1.1.1.1
Related
Commands
Command
Description
tunnel source
Configure the source address of the tunnel.
tunnel destination
Configure the destination address of a tunnel.
tunnel ttl
Configure the TTL of the tunnel.
Platform
Description
N/A
tunnel mode ipv6
Use this command to configure static IPv6 tunnel, which could carry the IPv4 or IPv6 message. Use
the no form of this command to restore it to the default IPv6 tunnel mode.
tunnel mode ipv6
no tunnel mode
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
The default mode is ipv6ip.
Command
mode
Interface configuration mode.
Usage Guide
Use this command to configure the 4over6 or 6over6 static tunnel.
Configuration
Examples
The following is the configuration example
Ruijie(config)# interface tunnel 1
Ruijie(config-if)# tunnel mode ipv6
Ruijie(config-if)# tunnel source vlan 1
Related
Commands
Command
Description
tunnel source
Configure the source address of the tunnel.
tunnel destination
Configure the destination address of a tunnel.
Tunnel ttl
Configure the TTL of the tunnel.
Platform
Supported by routers, but not by routers.

Ruijie RG-S2600G-I Series Specifications

General

Brand	Ruijie
Model	RG-S2600G-I Series
Category	Switch
Language	English