Ruijie RG-S2600G-I Series - Page 489

CLI Reference Network Connectivity Test Tool Configuration Commands
Sending 100, 1500-byte ICMP Echoes to 2000::1, timeout
is 3 seconds
< press Ctrl+C to break >
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Success rate is 100 percent (100/100), round-trip
min/avg/max = 2/2/3 ms
Platform
description
The command is supported by all ipv6 equipments.
traceroute
Execute the traceroute command to show all gateways passed by the test packets from the source address to the
destination address.
traceroute [vrf vrf-name | ip] [ip-address [probe number ] [source source] [timeout seconds] [ttl minimum
maximum]]
Parameter
description
Parameter
Description
vrf-name
VRF name
ip-address
Specifies an IPv4 address.
number
Specifies the number of probe packets to
be sent.
source
Specifies the source IPv4 address or the
source interface. The loopback interface
address(for example: 127.0.0.1) is not
allowed to be the source address.
seconds
Specifies the timeout time.
minimum
maximum
Specifies the minimum and maximum
TTL values.
Command
mode
Privileged EXEC mode.
Usage
guidelines
Use the traceroute command to test the connectivity of a network to
exactly locate the network connectivity problem when the network
failure occurs. To use the function domain name, configure the
domain name server. For the concrete configuration, refer to the DNS
Configuration part.
Examples
The following is two examples of the application bout traceroute, the
one is of the smooth network, and the other is the network in which
some gateways aren‟t connected successfully.
1. When the network is connected smoothly:
Ruijie# traceroute 61.154.22.36
< press Ctrl+C to break >