CLI Reference IGMP Snooping Configuration Commands
multicast requests to the router port of VLAN 1.
By default, the 2nd way is used.
The following example enables the IGMP packets
transparent transmission on the device:
Ruijie(config)# ip igmp snooping tunnel
Supported only after release 10.4(3).
ip igmp snooping vlan
Use this command to enable the igmp snooping on the specified vlan and enter the ivgl mode. The no
form of this command is used to disable the igmp snooping.
ip igmp snooping vlan vid
no ip igmp snooping vlan vid
Global configuration mode.
Use this command to enable or disable the IGMP snooping on the
specified vlan.
The pim snooping on the specified vlan
works only when the igmp snooping
configured. when disabling the igmp
snooping on the vlan with the pim
snooping configured, it prompts to
disable the pim snooping first and this
execution fails.
The following example enables the igmp snooping on the vlan2.
Ruijie(config)# ip igmp snooping vlan 2
To Next Page
Loading...
