Ruijie RG-S2600G-I Series - Page 558

CLI Reference IGMP Snooping Configuration Commands
ip igmp snooping vlan static interface
Once IGMP snooping is enabled, a port can receive a certain multicast frame without being affected by
various IGMP messages by executing the ip igmp snooping vlan static interface command in the
global configuration mode. The no form of this command is used to delete a static configuration.
ip igmp snooping vlan vid static ip-addr interface interface-type interface-name
no ip igmp snooping vlan vid static ip-addr interface interface-type interface-name
Parameter
description
Parameter
Description
vid
VLAN ID, in the range of 1 to 4094.
ip-addr
Multicast IP address
interface-type
interface-name
Interface name
Default
By default, no static member ports are configured.
Command
mode
Global configuration mode.
Usage
guidelines
Multiple multicast IP addresses can be configured for an interface.
Examples
Ruijie(config)# ip igmp snooping vlan 1 static 224.1.1.1 interface
GigabitEthernet 0/1
Related
commands
Command
Description
ip igmp snooping
vlan mdevice interface
Configure a multicast
routing interface
permit
To permit the forwarding of the multicast streams in the range specified by the profile, execute the
permit command in the profile configuration mode. In this way, the interface associated with this profile
will forward the specified multicast stream only.
permit
Parameter
description
N/A
Default
The forwarding of the multicast streams in the range specified by the
profile is denied.