CLI Reference MLD Snooping Configuration Commands
ipv6 mld snooping suppression enable
Use this command to enable the mld snooping suppression in the global configuration mode. Use the no
form of this command to disable this function.
ipv6 mld snooping suppression enable
no ipv6 mld snooping suppression enable
Global configuration mode.
With the IPv6 MLD snooping suppression function
enabled, within the query interval, the layer-2 device will
only forward the first received MLD Report packet in an
IPv6 multicast group to the layer-3 device, but not the
other MLD Report packets in the same IPv6 multicast
group, reducing the packet number in the network.
This command is used to enable the IPv6 MLD snooping
suppression, and only the MLDv1 Report packets are
suppressed rather than the MLDv2 Report packets.
The following example shows how to enable mld snooping
suppression:
Ruijie(config-if)# ipv6 mld snooping suppression
ipv6 mld source-check port
The source-check port is used to allow the multicast flow to enter through the mrouter interface. Use this
command to enable the mld source-check port in the global configuration mode. Use the no form of this
command to disable this function.
ipv6 mld snooping source-check port
no ipv6 mld snooping source-check port
To Next Page
Loading...
