CLI Reference RADIUS Configuration Commands
Define the RADIUS security server.
Define the duration when a device
stops sending any requests to an
unreachable Radius server.
Define the timeout for the packet
retransmission.
radius-server deadtime
The global configuration command is used to configure the duration when a device stops sending any
requests to an unreachable Radius server. The no form of this command is used to recover the default
value.
radius-server deadtime minnutes
no radius-server deadtime
Define the duration in minutes when the device
stops sending any requests to the unreachable
Radius server. The value is in the range of 1
min to 1440 min (24h).
The default value of minutes is 0 min, that is, the device keeps
sending requests to the unreachable Radius server.
Global configuration mode.
If active Radius server detection is enabled on the device, the time
parameter of this command does not take effect on the Radius
server. Otherwise, the Radius server becomes reachable when the
duration set by this command is shorted than the unreachable time..
The following example sets the duration when the device stops
sending requests to 1 min.
Ruijie(config)# radius-server deadtime 1
Define the RADIUS security server.
Define the criteria to determine that a
To Next Page
Loading...
