CLI Reference Web Authentication Configuration Commands
Access device port that is bound with the user’s IP
address
Enable/Disable ARP binding
show web-auth port-control
This command is used to display the authentication configuration and statistics of an interface.
show web-auth port-control
Example 1: Display the authentication configuration and statistics of an interface.
Ruijie# show web-auth port-control
Port Control
----------------- ---------
FastEthernet 0/1 On
FastEthernet 0/2 On
FastEthernet 0/3 Off
......
Physical port of the access device.
Enable/Disable Web authentication on the port
Enable the Web authentication on the port.