Ruijie RG-S2600G-I Series - Page 704

CLI Reference Web Authentication Configuration Commands
online users connected to the physical interface are forced to log off.
They must be authenticated again.
Defaults
Web authentication is disabled on port.
Command
Mode
Interface configuration mode
Usage Guide
To use the Web function, the address of the authentication homepage must be configured.
Configuration
Examples
Example 1: Enable Web authentication on port FastEthernet 0/14.
Ruijie(config)# interface FastEthernet 0/14
Ruijie(config-if)# web-auth port-control
Related
Commands
Command
Description
show web-auth port-control
Display the Web authentication information of
the port.
http redirect
Set the IP address of the authentication server.
http redirect homepage
Set the address of the authentication
homepage.
web-auth portal key
Set the communication key between the access
device and the authentication server.
Platform
Description
None
web-auth update-interval
This command is used to set the interval at which the online user information is updated. The no form
of this command is used to reset the interval at which the online user information is updated to 60s.
web-auth update-interval seconds
no web-auth update-interval
Parameter
Description
Parameter
Description
seconds
Update interval in seconds. It is in the range of 30 to 3600.
Defaults
The online user information is updated every 60s.
Command
Mode
Global configuration mode
Usage Guide
The access device maintains the online user information (including online duration) and updates it at
certain interval, to monitor the network resource used by online users.