Ruijie RG-S2600G-I Series - Page 720

CLI Reference Port-based Flow Control Configuration Commands
Port-based Flow Control Configuration Commands
protected-ports route-deny
Use this command to configure the L3 routing between the protected ports. Use the no form of the
command to disable theL3 routing.
protected-ports route-deny
no protected-ports route-deny
Default
configuration
Enabled.
Command
mode
Global configuration mode.
Usage
guidelines
After setting some ports as the protected ports, they can route on L3. Use this
command to deny the L3 communication between protected ports. Use show
running-config to display configuration.
Examples
Ruijie(config)# protected-ports route-deny
Related
commands
Command
Description
show running-config
Show whether the route-deny between protected
ports has been configured.
storm-control
Use this command to enable the storm suppression. Use the no form of the command to disable the
storm suppression.
storm-control {broadcast | multicast | unicast} [{level percent | pps packets|rate-bps}]
no storm-control {broadcast|multicast|unicast}[{level percent | pps packets|rate-bps}]
Parameter
description
Parameter
Description
broadcast
Enable the broadcast storm suppression function.
multicast
Enable the unknown unicast storm suppression
function.
unicast
Enable the unknown unicast storm suppression
function.