CLI Reference NFPP Configuration Commands
log-buffer logs
Use this command to set the rate of syslog generated from the NFPP log buffer area.
log-buffer logs number_of_message interval length_in_seconds
The valid range is 0-1024.
0 indicates that all logs are
recorded in the specific buffer area
and no syslogs are generated.
The valid range is 0-86400(one
day).
0 indicates not to write the log to
the buffer area but generate the
syslog immediately.
With both the number_of_message
and length_in_seconds values are
0, it indicates not to write the log to
the buffer area but generate the
syslog immediately.
The parameter
number_of_message
/length_in_second indicates the
rate of syslog generated from the
NFPP log buffer area.
By default, the number_of_message is 1 and the length_in_seconds
is 30.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# log-buffer logs 2 interval 12
log-buffer ent
ries number
Set the NFPP log buffer
area size.
To Next Page
Loading...
