Ruijie RG-S2600G-I Series - Page 883

CLI Reference NFPP Configuration Commands
Rate-limit
In the format of the rate-limit
threshold for the source IP address/
the rate-limit threshold for the
source MAC address/ the rate-limit
threshold for the port
Attack-threshold
In the same format as the rate-limit.
-
No configuration.
Related
commands
Command
Description
dhcp-guard
attack-threshold
Set the global attack threshold.
dhcp-guard enable
Enable the DHCP anti-attack
function.
dhcp-guard
isolate-period
Set the global isolate time.
dhcp-guard
monitor-period
Set the monitor period.
dhcp-guard
monitored-host-li
mit
Set the maximum number of the
monitored hosts.
dhcp-guard
rate-limit
Set the global rate-limit threshold.
nfpp dhcp-guard
enable
Enable the DHCP anti-attack
function on the interface.
nfpp dhcp-guard
isolate-period
Set the isolate time.
nfpp dhcp-guard
policy
Set the rate-limit threshold and
attack threshold.
show nfpp dhcpv6-guard hosts
Use this command to show the monitored host.
show nfpp dhcpv6-guard hosts [statistics | [[vlan vid] [interface interface-id] [ip-address |
mac-address]]]
Parameter
description
Parameter
Description
statistics
Show the statistical information of
the monitored host.
vid
The VLAN ID.