Ruijie RG-S2600G-I Series - Page 995

CLI Reference RLDP Configuration Command
RLDP Configuration Command
rldp enable
Use this command to enable RLDP globally. Use the no form of this command to disable the function.
rldp enable
no rldp enable
Parameter
description
N/A.
Default
Disabled.
Command
mode
Global configuration mode.
Usage
guidelines
You can enable RLDP on the interface only when the global RLDP is
enabled.
Examples
The following example shows how to enable RLDP:
Ruijie(config)# rldp enable
Related
commands
Command
Description
rldp port
Enable the RLDP function on the port.
rldp detect-interval
Use this command to configure the interval at which the RLDP sends the detection message on the port. Use the
no form of this command to restore it to the default value.
rldp detect-interval interval
no rldp detect-interval
Parameter
description
Parameter
Description
interval
Detection interval in the range 2 to 15 seconds
Default
3 seconds.
Command
mode
Global configuration mode.