Section 05 ENGINE (4-TEC)
Subsection 07 (CYLINDER HEAD AND VALVES)
Installation
For installation, reverse the removal procedure.
Pay attention to the following details.
Install valve stem seal no. 28.
1
R1503motr254A
1. Valve stem seal
Apply engine oil on valve stem and install it.
CAUTION: Be careful when valve stem is
passed through sealing lips of valve stem seal.
R1503motr254B
1
1. Sealing lips of valve stem seal
To ease installation of cotters, apply oil or grease
on them so that they remain in place while releas-
ing the spring.
After spring is installed, ensure it is properly
locked by tapping on valve stem end with a soft
hammer so that valve opens and closes a few
times.
CAUTION: An improperly locked valve spring
will cause engine damage.
smr2004-Complete Line Up 271
To Next Page
Loading...
Need help?
General
