247
5 Setup Data
5.4 Setup2 Editor
Further information:
Table Tools [-> 244]
File tools [-> 245]
Helpers for Input [-> 239]
Overview of the Setup2 Editor of the CMS [-> 237]
Setup Data [-> 233]
Comparing Setup1 to Setup2 [-> 235]
WM+C Monitoring of main take-down. If the
take-down has not been used after n (0-
100) knitting rows, the machine will stop.
(0 = no supervision)
Minimum value: 0
Maximum value: 100
Step width: 1
WMK+C Controlling the comb. If the comb has not
moved after n (0-100) knitting rows, the
machine will stop. (0 = no supervision)
Minimum value: 0
Maximum value: 100
Step width: 1
Comment Comment ASCII Characters
Explanation Value range
To Next Page
Loading...
