Setup Data 5
Setup2 Editor 5.4
262
NP (Knitting Mode) / Wheel Display showing which stitch cam position works together with which
measuring wheel.
The list is filled out automatically (mode "Working with mm", program item
"Determine basic conditions").
Further information:
Helpers for Input [-> 239]
File tools [-> 245]
Table Tools [-> 244]
Setup Data [-> 233]
Overview of the Setup2 Editor of the CMS [-> 237]
Comparing Setup1 to Setup2 [-> 235]
Explanation
"front" Stitch cam position on the front needle bed
"Back" Stitch cam position on the rear needle bed
"Wheel" Measuring wheel
"Active" Selection for program item "Production":
The stitch cam position is controlled with YLC.
The stitch cam position is not controlled with YLC.
"Comment" Comment (ASCII Characters)
To Next Page
Loading...
