126 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
TP2700>show ptp master config eth2 itu-g8265-1
Response 6:
EHT2 PTP MASTER CONFIGURATION WITH PROFILE ITU-G8265-1:
PTP State : enable
PTP TTL : 64
PTP DSCP : 0
PTP Dither : disable
PTP Max Number Clients : 256
PTP Two Steps : disable
PTP Unicast Negotiation : enable
PTP Unicast Lease Duration : 300
PTP Sync Limit : -7
PTP Announce Limit : -3
PTP Delay Limit : -7
PTP Clock Id : 00:b0:ae:ff:fe:03:46:05
PTP Priority 1 : 128
PTP Priority 2 : 128
PTP Domain : 4
PTP Timescale : auto
Example 7:
To show the default profile (Layer 3 multicast) configuration info for PTP master on
ETH2 port:
TP2700>show ptp master config eth2 default
Response 7:
ETH2 PTP MASTER CONFIGURATION WITH PROFILE DEFAULT:
PTP State : enable
PTP Vlan ID : 0
PTP TTL : 16
PTP DSCP : 0
PTP Dither : disable
PTP Max Number Clients : 8
PTP Two Step : enable
PTP Clock Id : 00:b0:ae:ff:fe:03:46:05
PTP Priority 1 : 128
PTP Priority 2 : 128
PTP Timescale : auto
PTP Announce Interval : 1
PTP Sync Interval : 0
PTP Announce Receipt Timeout : 3
PTP Multicast Client Timeout : 300
PTP Domain : 0
To Next Page
Loading...
Need help?
General