Symmetricom TimeProvider 2700 User Manual

146 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
 delay-limit
 priority-1
 priority-2
 domain
 timescale
Refer to Table B-39, Table B-40, and Table B-41 in Appendix B for range and default
values for PTP parameters.
TP2700>set ptp master config eth2 telecom-2008 ptp-state enable
TP2700>set ptp master config eth2 telecom-2008 ttl 100
TP2700>set ptp master config eth2 telecom-2008 dscp 5
TP2700>set ptp master config eth2 telecom-2008 dither enable
TP2700>set ptp master config eth2 telecom-2008 two-step enable
TP2700>set ptp master config eth2 telecom-2008 unicast-negotiation
enable
TP2700>set ptp master config eth2 telecom-2008 lease-limit 300
TP2700>set ptp master config eth2 telecom-2008 announce-limit -4
TP2700>set ptp master config eth2 telecom-2008 sync-limit -7
TP2700>set ptp master config eth2 telecom-2008 delay-limit -7
TP2700>set ptp master config eth2 telecom-2008 priority-1 128
TP2700>set ptp master config eth2 telecom-2008 priority-2 128
TP2700>set ptp master config eth2 telecom-2008 domain 8
TP2700>set ptp master config eth2 telecom-2008 timescale auto
Example 3:
To set the active-profile of PTP master in eth2 port as itu-g8265-1:
TP2700>set ptp master active-profile eth2 itu-g8265-1
Example 4:

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English