Symmetricom TimeProvider 2700 User Manual

148 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
TP2700>set ptp master config eth2 itu-g8265-1 domain 0
TP2700>set ptp master config eth2 itu-g8265-1 timescale auto
Example 5:
To set the active-profile of PTP master on ETH2 port as default:
TP2700>set ptp master active-profile eth2 default
Example 6:
To provision the following attributes of profile default for PTP master in eth2 port:
 ptp-state
 ttl
 dscp
 dither
 two-step
 priority-1
 priority-2
 timescale
 domain
 announce-receipt-timeout
 announce-interval
 sync-interval
 client-timeout
Refer to Table B-39, Table B-40, and Table B-41 in Appendix B for range and default
values for PTP parameters.
TP2700>set ptp master config eth2 default ptp-state enable
TP2700>set ptp master config eth2 default ttl 20
TP2700>set ptp master config eth2 default dscp 25
TP2700>set ptp master config eth2 default dither enable
TP2700>set ptp master config eth2 default two-step enable

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English