Symmetricom TimeProvider 2700 User Manual

098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 149
Chapter 3
TimeProvider 2300/2700 CLI Command Set
TP2700>set ptp master config eth2 default priority-1 200
TP2700>set ptp master config eth2 default priority-2 200
TP2700>set ptp master config eth2 default domain 10
TP2700>set ptp master config eth2 default timescale auto
TP2700>set ptp master config eth2 default announce-interval 2
TP2700>set ptp master config eth2 default sync-interval -6
TP2700>set ptp master config eth2 default announce-receipt-timeout 4
TP2700>set ptp master config eth2 default client-timeout 100
Example 7:
To set the active-profile of PTP client in eth1 port as telecom-2008:
TP2700>set ptp client active-profile eth1 telecom-2008
Example 8:
To provision the following attributes of profile telecom-2008 for PTP client in eth1
port:
 ptp-state
 ttl
 dscp
 unicast-negotiation
 lease-duration
 announce-interval
 sync-interval
 delay-req-interval
 announce-receipt-timeout
 domain
Refer to Table B-39, Table B-40, and Table B-41 in Appendix B for range and default
values for PTP parameters.
TP2700>set ptp client config eth1 telecom-2008 ptp-state enable

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English