TOMATECH TAC-100XT User Manual

TOMATECH AUTOMATION
Address Address
characters
Function
CN62.03 Y0.2 HOLD HOLD release output
� Control parameter
PLC state parameter
K 1 8 HOLD
HOLD =0：HOLD release control is invalid.
=1：HOLD release control is valid.
� Function
Chapter 2 Definition and Connection of Interface Signal
367
Ⅲ Connection
1. After power-on, there is no emergency stop alarm or servo spindle alarm and the
system delays 4S,
HOLD signal is output to release HOLD.
2. HOLD signal is closed when an emergency stop alarm or servo spindle alarm occurs.
2.8.25 Gear/tool number display
� Signal diagnosis
Y0025 BIT7 BIT6 BIT5 BIT4 BIT3 BIT2 BIT1 BIT0
Corresponding
BCD code
LED1
23
LED1
22
LED1
21
LED1
20
LED0
23
LED0
22
LED0
21
LED0
20
LED 0 displays the current tool number, BIT0~BIT3 of PLC diagnosis number Y25 are
BCD code
of the current tool number; LED 1 displays the gear of the current spindle, BIT4~BIT7 of
PLC
diagnosis number Y25 are BCD code of the current spindle gear and is shown below:
� Function description

TOMATECH TAC-100XT Specifications

General

Brand	TOMATECH
Model	TAC-100XT
Category	Control Systems
Language	English