TOMATECH AUTOMATION
0 1 1 1 0 15
0 1 1 1 1 16
1 0 0 0 0 17
1 0 0 0 1 18
1 0 0 1 0 19
1 0 0 1 1 20
1 0 1 0 0 21
1 0 1 0 1 22
Chapter 3 Parameters
373
Volume Ⅲ Connection
1 0 1 1 0 23
1 0 1 1 1 24
1 1 0 0 0 25
1 1 0 0 1 26
1 1 0 1 0 27
1 1 0 1 1 28
1 1 1 0 0 29
1 1 1 0 1 30
1 1 1 1 0 31
1 1 1 1 1 32
0 1 1 BDEC BD8 *** *** NORF ZNIK *** ***
Bit7 1: Backlash offset type B, the offset data are output by ascending or descending type
and the
set frequency is inactive;
0: Backlash offset type A, the offset data are output by the set frequency (by bit parameter
No.010) or 1/8 of it.
Bit6 1: Backlash offset is done by the 1/8 of the set frequency
0: Backlash offset is done by the set frequency
Bit3 1: Manual machine zero return inactive
0: Manual machine zero return active
Bit2 1: Direction key locked during zero return, homing continues to end by pressing
direction key
once;
0: Direction key unlocked, which is held on during zero return
0 1 2 APRS WSFT DOFSI *** EAL *** EBCL ISOT
Bit7 1: Automatic ABSOLUTE set after reference return,;
0: ABSOLUTE not automatically set after reference return
Bit6 1: Workpiece coordinate offset active, defined by offset No.000
0: Workpiece coordinate offset inactive
Bit5 1: Trial tool setting active
0: Trial tool setting inactive
Bit3 1: Program editing allowed during CNC alarming
0: Program editing unallowed during CNC alarming
To Next Page
Loading...