TOMATECH AUTOMATION
0 4 0 GRMAX4
［Data meaning］ GRMAX1, GRMAX2, GRMAX3, GRMAX4: Max. speeds of gear 1, 2, 3,
4
respectively when spindle analog voltage output is 10V (the function defined
byTAC-1002T PLC is: if the spindle automatic gearing is active, it uses the
speeds of M41, M42, M43, M44; if the automatic gearing is inactive or CNC is
powered on, the gear is memorized by parameter or the gear 1 is defaulted.)
［Data unit］ r/min
［Data range］ 10～9999
382
Volume Ⅲ Connection
0 4 1 JOGFL
［Data meaning］ Exponential ac-deceleration start speed and deceleration final speed in
manual feed
［Data unit］
Setting unit Data unit
Metric machine mm/min
Inch machine 0.1inch/min
［Data range］ 0～8000
0 4 2 SEQINC
［Data meaning］ Block No. increment for auto block No. insertion
［Data range］ 1～100
0 4 3 LOWSP
［Data meaning］ (G96) Spindle min. speed under the constant surface speed control
［Data unit］ r/min
［Data range］ 0～9999
0 4 4 BRATE0
［Data meaning］ Serial communication baud rate,
［Data unit］ bit/s
［Data range］ 1200,2400,4800,9600,19200,38400 57600 115200
0 4 5 LT1X1
0 4 6 LT1Z1
［Data type］ Word axis
［Data meaning］ LT1X1（X）,LT1Z1（Z）positive max. travel，LT1X2（X）,LT1Z2（Z）
negative
max. travel
［Data unit］
Setting unit IS-B IS-C
Metric machine 0.001 mm 0.0001 mm
Inch machine 0.0001 inch 0.00001 inch
［Data range］ -99999999～99999999
Note: If the BIT2 of the parameter No.001 is set for diameter, the X axis value is specified by
diameter; if for
To Next Page