Multi Pro 5800 Page 8 − 15 GeoLink Spray System
Job Information Menu
The job information menu (Fig. 13) displays information
about the current spray jobs progress through the fol-
lowing sub−menus and screens:
Job Area Statistics
Job Time Statistics
Guidance Settings
Job Notes (edit task data)
Figure 13 − Job Information Menu
Automatic Section Control Menu
The automatic section control menu (Fig. 14) permits
the system to turn nozzles ON for new areas to be cov-
ered and OFF for areas that have already been covered.
Control (coverage overlap − percentage): con-
trols when a spray nozzle will turn ON or OFF based
on the previous pass or boundary.
NOTE: ASC must be set to ON to utilize the coverage
overlap feature.
The default Toro spray pattern is 20 in. wide, and the
default coverage overlap setting is 50(%). This
means that if a nozzle overlaps the previous pass by
less than 50% (10 in.) the nozzle will stay ON, or a
nozzle that overlaps the previous pass by 50% or
more will turn OFF.
Boundary Limit (field boundary/unlimited): sets
the spray system to recognize previously defined
boundaries (boundary limit − Field Boundary), or
only use pass−to−pass (overlap) control (boundary
limit − Unlimited
NOTE: ASC must be set to ON to utilize the bound-
ary limit feature.
Automatic Section Control (ASC) ON/OFF: sets
the system to turn spray nozzles ON when entering
new areas, and turn nozzles OFF when passing over
previously sprayed areas
1. Control mode
(coverage overlap)
2. Boundary limit
3. Automatic section
control
Figure 14
3
2
1
GeoLink
Spray System
To Next Page
Loading...
