Multi Pro 5800Page 8 − 16GeoLink Spray System
Spray Controller Menu
The spray controller menu reports various aspects of
the current spray application function in real time. A
mini menu appears first (Fig. 15). Pressing the ex-
pand icon in the upper right corner of the mini menu
exposes the full menu (Fig. 16).
With the exception of the application rate adjust but-
tons, all other items on this menu are for information
only.
1. Current application rate
2. Current system pressure
3. Rate control
(auto/manual)
4. Expand to full menu
5. Target application rate
6. Application rate adjust
7. Pre−set application rat
Figure 15 − Mini Menu
3
2
1
5
6
7
4
1. Current application rate
2. Current system pressure
3. Target application rate
4. Application rate adjust
5. Pre−set application rates
6. Rate control (auto/manual)
7. Product tank info
8. Stationary test speed
9. Flow meter calibration
10. Nozzle valve state
Figure 16 − Full Menu
Similar to the sprayer icon on the
operation screen, the nozzle valve
icons will change color during oper-
ation to indicate the following:
Red: boom switched OFF, all
nozzles on the boom disabled
Blue: boom switched ON, all noz-
zles on the boom are enabled and
available to spray but no product
is flowing from the nozzle (typical-
ly due to low vehicle speed)
Yellow: boom switched ON, all
nozzles on the boom are enabled
and available to spray but no
product is flowing from the nozzle
(typically due to automatic sec-
tion control of nozzle)
Green: boom switched ON, all
nozzles on the boom are enabled
and available to spray and prod-
uct is flowing from the nozzle
The circular indicators at the bottom
of the screen indicate valve state
and will be either red (manually dis-
abled) or green (manually enabled).
3
2
1
4
5
6
9
8
7
10
To Next Page
Loading...
