Multi Pro 5800 ChassisPage 9 − 23
Removal (Fig. 23)
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Raise and latch seat.
3. Disconnect seat switch from machine wire harness
(Operator seat only).
4. Remove two (2) carriage screws and flange nuts se-
curing hinged seat panel to seat box.
5. Slide seat assembly forward until prop rod can be re-
moved from slot in console base and lift seat assembly
from machine.
6. Repeat steps 4. and 5. for remaining seat assembly.
7. Record fastener location in mounting slot and re-
move four (4) flange head screws and flat washers se-
curing seat to hinged seat panel and remove seat if
necessary.
8. Remove hex nut and cap screw securing prop rod
bracket to seat panel and remove prop rod and bracket
if necessary.
Installation (Fig. 23)
1. Install prop rod and bracket to seat panel if previously
removed.
NOTE: Seat mounting slots in hinged seat panel are
slotted to afford some seat adjustment for operator com-
fort.
2. Install seat to seat panel with four (4) flange head
screws and flat washers. Locate screws in seat panel
slot position recorded during removal before tightening.
3. Pass prop rod through slot in console base and se-
cure hinged seat panel to seat box with two (2) carriage
screws and flange nuts.
4. Connect seat switch to machine wire harness (Oper-
ator seat only).
Chassis
To Next Page
Loading...
Need help?
General
