Yealink T40G Administrator's Guide

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
74
contained in the configuration file and set to 1.
If the IP phone reboots repeatedly after it is set to 1, you can try to set
“static.auto_provision.power_on" to 0 (Off).
Permitted
Values
0-Disabled
1-Enabled
Default
Blank
Parameter
features.action_uri_force_autop
<y0000000000xx>.cfg
Description
It enables or disables the IP phone to end the call for triggering auto provisioning
immediately when receiving an HTTP or HTTPS GET request with variable value set to
AutoP during a call.
Note: It works only if “features.action_uri.enable” is set to 1 (Enabled).
Permitted
Values
0-Disabled, the IP phone will trigger auto provisioning after the call.
1-Enabled
Default
0
Parameter
static.auto_provision.power_on
<y0000000000xx>.cfg
Description
It triggers the power on feature to on or off.
Permitted
Values
0-Off
1-On, the IP phone will perform auto provisioning when powered on.
Default
1
Web UI
Settings->Auto Provision->Power On
Parameter
static.auto_provision.repeat.enable
<y0000000000xx>.cfg
Description
It triggers the repeatedly feature to on or off.
Permitted
Values
0-Off
1-On
Default
0
Web UI
Settings->Auto Provision->Repeatedly
Parameter
static.auto_provision.repeat.minutes
<y0000000000xx>.cfg
Description
It configures the interval (in minutes) for the IP phone to perform auto provisioning
repeatedly.
Note: It works only if “static.auto_provision.repeat.enable” is set to 1 (On).
Permitted
Values
Integer from 1 to 43200
Default
1440

Yealink T40G Specifications

General

SIP Accounts	3
Wall Mountable	Yes
Opus Codec	No
Display	2.3 inch 132x64-pixel graphical LCD
Network	Dual-port Gigabit Ethernet
PoE	Yes
Headset Support	Yes, RJ9 port
Power Adapter	Optional
Voice Codecs	G.722, G.711(A/μ), G.729AB, G.726
Local Phonebook	1000 entries